Best Hunting Game Feeder Parts & Accessories in 2022

Last update: November 29, 2022

Moultrie Universal Digital Timer Feeder, Pack of 1 Review:


There are two differences between these timers and the ones that are pre-installed on Moultrie feeders, which means you will need to change your current arrangement to make room for the new timer. The timer was first attached to the frame of my feeder with two screws that were inserted into plastic mounts that ran through openings on either side of the original timer. Second, the old timer's wires emerged from the timer in the middle of the back. The frame mounting tabs on the new timer were not attached by holes, but that is no problem—just break off the mounting tabs using pliers, and any remaining plastic can be removed with a sharp knife. This enables the new timer's flat back to make direct touch with the old frame. The new timer wiring exits the timer on the right side, but that's no problem because the wires to the motor and battery clips are long enough and a Dremel tool or sturdy knife can notch the frame just enough to allow the wiring to loop around to the rear of the frame when the cover is attached. An extra wire tie was used between the set buttons and display for added security in case the super glue decided it didn't want to permanently bind the plastic timer housing to the plastic frame. Mounting to the frame was completed by dabbing some super glue gel on the back of the timer and front of the frame. It took around 15 minutes to replace everything.I particularly value the wiring harness It makes life much easier when working in a small space not to have to strip and splice wires, so Moultrie added a piece that you solder to the motor tabs and that has a snap fastener on the other end that hooks up to the wire harness coming off the timer. Only a little amount of heat shrink tubing to go over the soldered motor tabs (as per the original installation) and a larger tube to fit over the snap fastener to keep moisture out of those contacts may have been added to finish the package.



Lilbees Hog Feeder Light Motion Activated Green Light for Predator Coyote Pig Varmint Deer Hog Night Hunting(Pack of 3) Review:


I use these lights on a number of feeders and adore them. They are well-charged by the solar panels. To ensure that each feeder has enough light, I use two. can employ scope without difficulty. The only problem is that they have a harsh glare, so avoid turning them on immediately where you are hunting. Spend less money on batteries. Without a doubt, I'd suggest it and would purchase more.



ARTITAN Feeder Light Hog Hunting Green Light Motion Sensor Light 120°Angle for Predator Coyote Pig Varmint Deer Night Hunting Review:


With this light, I can connect the device without running power or changing batteries, which will help me save money on my electricity cost. When completely charged, this light functions fantastically! With this buy, I'm quite pleased. I only bought one to test how well it worked, but I'll be buying more immediately!



Lilbees Solar Green Feeder Lights with Motion Activated for Hog Pig Predator Coyote Varmint Deer Night Hunting(Pack of 2) Review:


The lights are gorgeous! They have a strong charge, are sufficiently intelligent for the job, don't spook the hogs, and are visible from a great distance. You can attach the lights to a tree or flat plate using the included brackets, or you can use baling wire to attach to a T-post. There are no further drawbacks outside the inconvenience of the internal on/off switch. I absolutely want to purchase additional of these lights for use when hunting or trapping hogs.



Moultrie Feeder Power Panel | 6-Volt | Built in Battery Indicator Review:


This panel has been connected to my timed feeder for about three months, and it has operated perfectly. Every two weeks, I check on the feeder and refill it, and each time, the solar panel battery and the feeder batteries have both been fully charged. The feeder receives little sunshine because it is surrounded by oak trees, yet it still manages to keep my batteries fully charged and prepared for use.This is a fantastic gadget that, by avoiding the need to replace my 6v batteries, will eventually pay for itself.



TRAIL WATCHER Deer Feeder Light Hog Hunting Green Light Spotlight PIR Motion Sensor 120°Angle IP65 Waterproof Outdoor Animal Game Feeder Cage Review:


The necessity for 4 D cell batteries is explained by the fact that the light is bigger than I anticipated. It casts a fairly strong light and seems to perform fairly well. I'm not sure why it is green because red light waves would be better for hunting because they do not scare off many creatures. The small rubber gasket within the light was the only problem. When loading batteries, it is simple to snap off and a hassle to put back on. The band is essential because it protects the battery housing from the elements. Because of this, I gave the product a rating of less than 5.



Elusive Wildlife Kill Light Sportsman Motion Activated Feeder Light Review:


outstanding product Although I have purchased many hog lights, this one is by far the finest so far. puts all the others to shame, thanks guys, and I'll be buying more for the upcoming season.



Moultrie Feeder Activator | Remote Control | Compatible with 6 or 12-Volt Feeders Review:


I wished I had bought these sooner after receiving the product less than a week ago. Installing it to my 12V feeder only took a few minutes, and when put to the test, it operated flawlessly. It worked perfectly the first time I used it while hunting, and by enabling me to throw more corn as needed, it helped me keep deer in the area of my stand for nearly 2 hours. I don't know if it really reaches out to 300' as stated because I bow hunt, and my setup is at a range of 60 to 80'. However, I do know that it works fantastically for my setup. Because of some of the complaints I read, I initially only bought 2 of these, but they both functioned and were simple to install, requiring only the included electrical clips and no splicing of wires. I would strongly suggest it at this point based on my little usage, and I have already just ordered two more units for my other feeders.