Best Hubcaps in 2020



BDK Wheel Guards – (4 Pack) Hubcaps for Car Accessories Wheel Covers Snap Clip-On Auto Tire Rim Replacement for 16 inch Wheels 16” Hub Caps (Replica for Toyota) Review:


A good deal for the money... After all what are we spending about 6 bucks a piece?

Because of the thin edge you can see the wire that keeps it latched to the wheel.

I gave it 4 stars bc of the low price & it does have a nice paint job.

I put these on a 2015 Toyota Corolla.
Here is a pic of factory as well as a pic of these and as you can see the wire is quite visible.

Guess that will go away once it gets dirty... Lol!

As you can see bc of the thin edge you not only can see the wire but less of the ugly wheel is covered by the hub cap.



Hubcaps 16 inch Wheel Covers - (Set of 4) Hub Caps for 16in Wheels Rim Cover - Car Accessories Silver Hubcap Best for 16inch Cars Standard Steel Rims - Snap On Auto Tire Replacement Exterior Cap Review:


OxGord Hubcaps for 16 inch Standard Steel Wheels (Pack of 4) Wheel Covers - Snap On, Silver -- I must say one of the better purchases I have made for my 2010 Chevrolet Impala. By trying to avoid an accident by swerving to my left, I hit a concrete median so hard that it bent both rims (front & back) on the driver side and of course the original hubcaps were completely destroyed. Being the car is 8 years old did not want to spend almost $300 for original Chevrolet Impala hubcaps. I saw these and look similar and again could not be more happier. They were received with no issues. Shipping box was not damaged in any way and when opened they were better looking than I thought they would be. I was able to put on all 4 in under 20 minutes with no problems.



Alpena 58260 VR Carbon Wheel Cover Kit - Black - 16-Inch - Pack of 4 Review:


These fit my vehicle fine. I played with the settings (the red thing that connects the wires) until the medium worked. Had to check and double check the tire stem was in the correct location. Once on they have not come loose.

Overall look is fine in the semi-matte black. Have not lost one since purchasing (90 days or so, with some rough roads and 1000's of mile).

If this is your flavor of wheel cover, get them and spend a few minutes checking and installing correctly. Mine had to be lightly hand-banged on for the last little bit to fit flush. Not HARD, mind you.... Just tapping lightly. One I had to hit a bit harder (it had more well weights than the others or the rim was slightly tweaked/dirty/etc.) and it felt like it might crack. No cracks as of yet (have had them on and off at least 5 times), and they have stayed on well. After the 1st time putting them on, I went back around and hit them a few times to make sure they were seated - one was slightly off, but probably due to me not installing them all the way. No hammers!!!

Long-term, they seems to have held up. I think the red has MAYBE faded slightly, but in my eyes this is okay. Or perhaps I just need to wash them.



Pilot Automotive WH553-15S-BS Universal Fit Spyder Wheel Cover [Set of 4] - 15 in. ABS Hub Cap with 10 Spokes, Black/Silver Finish. Car Accessories Review:


Over all I'm very satisfied with this purchase.For just under 45 bucks these covers can transform your cars image. So a couple of things to know before you buy, there will be a very brief setup before your able to install these covers . When you get the covers they'll come with four metal rings that should be at attached to the covers themselves, you will have to set them yourself and adjust them yourself, the makers provide a sort of setup step guide , but I found it a little overwhelming/unhelpful.I included the pamphlet in a pic but it basically states that there's three sizes you can make for the covers small,medium,large (Simple right). Once you determine which size you want you will have to follow a couple steps

1.place the metal rings on the back of the cover (out side the prongs )
2.find the prong that determines the size variations you selected and place the ends of the rings into it
3 .you will now have to snap the entire ring on the outside of the prongs,inside the prongs ( it gets tougher to snap into place the longer you do this step, but I believe in you guys )
4.Now you should have a sturdy ring on your cover so now you just install on your car

Tips
-please match your air valve to the groove in the cover
-the tire valve should fit over the metal ring or else It will pinch
-pull on your tire covers when installed to make sure they don't easily come off
-if your having problems installing on your car check the metal rings / it might have come loose from a prong/or its just to small a size, so adjust



Pilot Automotive WH553-16S-BS Universal Fit Spyder Wheel Cover [Set of 4] - 16 in. ABS Hub Cap with 10 Spokes, Black/Silver Finish. Car Accessories Review:


Over all I'm very satisfied with this purchase.For just under 45 bucks these covers can transform your cars image. So a couple of things to know before you buy, there will be a very brief setup before your able to install these covers . When you get the covers they'll come with four metal rings that should be at attached to the covers themselves, you will have to set them yourself and adjust them yourself, the makers provide a sort of setup step guide , but I found it a little overwhelming/unhelpful.I included the pamphlet in a pic but it basically states that there's three sizes you can make for the covers small,medium,large (Simple right). Once you determine which size you want you will have to follow a couple steps

1.place the metal rings on the back of the cover (out side the prongs )
2.find the prong that determines the size variations you selected and place the ends of the rings into it
3 .you will now have to snap the entire ring on the outside of the prongs,inside the prongs ( it gets tougher to snap into place the longer you do this step, but I believe in you guys )
4.Now you should have a sturdy ring on your cover so now you just install on your car

Tips
-please match your air valve to the groove in the cover
-the tire valve should fit over the metal ring or else It will pinch
-pull on your tire covers when installed to make sure they don't easily come off
-if your having problems installing on your car check the metal rings / it might have come loose from a prong/or its just to small a size, so adjust



Pilot Automotive WH553-17S-BS Black/Silver 17 Inch 17" Spyder Performance Wheel Cover (Pack of 4) Review:


Well made wheel covers that have the right amount of flexibility even at freezing temperatures. These flexible ABS plastic covers should mean that they are less likely to crack or snap while being removed or installed. I’ve just put them on a 2011 Honda Accord so I can’t speak to the durability of the finish, or the possibility that the plastic will become more brittle over time. The wire tension ring offers 3 variations to adjust how tightly the cover snaps onto the wheel. The tension ring does NOT have a notch or indentation to accommodate the valve stem. I was able to bend a notch into each tension ring and I took a close-up picture to show how this was needed in order to install the covers. I think it’s poor design to notch the plastic cover but not the tension ring. Additionally, adding a notch to the ring reduced the diameter slightly, so I had to use the highest tension position to ensure the covers clipped onto the wheel properly. Overall I’m happy with the new look but caution that some applications may have issues with fitment due to the valve stem.



BDK HK993 15" Silver Hubcaps Wheel Covers for Toyota Corolla (15 inch) – Four (4) Pieces Corrosion-Free & Sturdy – Full Heat & Impact Resistant Grade – OEM Replacement, 4 Pack Review:


Bought these to replace a missing hubcap on son's 2007 Toyota Corolla. Needless to say, I didn't want to buy expensive OEM hubcaps for a nine-year-old car, but these work just fine. They look good and generally blend in with the original hubcaps (they're not exact replicas). I'm fairly certain that a casual observer would not notice the difference unless I drew his or her attention to the fact that one of the hubcaps was an inexpensive aftermarket one. The material is durable and the metal ring stiffeners ensure that the hubcap stays in place. As original hubcaps age (especially here in the Texas heat), the tabs become increasingly brittle and are likely to break off with routine tire rotations and/or everyday driving over rough roads and potholes. These replacement hubcaps help keep the car looking good at a reasonable price should an original hubcap go missing.



BDK Wheel Guards – (4 Pack) Hubcaps for Car Accessories Wheel Covers Snap Clip-On Auto Tire Rim Replacement for 16 inch Wheels 16” Hub Caps (Medium Spokes) Review:


A good deal for the money... After all what are we spending about 6 bucks a piece?

Because of the thin edge you can see the wire that keeps it latched to the wheel.

I gave it 4 stars bc of the low price & it does have a nice paint job.

I put these on a 2015 Toyota Corolla.
Here is a pic of factory as well as a pic of these and as you can see the wire is quite visible.

Guess that will go away once it gets dirty... Lol!

As you can see bc of the thin edge you not only can see the wire but less of the ugly wheel is covered by the hub cap.



BDK KT-978-15_AMwng1 Silver 15 Inch Hubcaps Wheel Protection-4 Lug Nuts, OEM Replica Replacement Hub Cap Covers, Easy Installation, Total 4 Pieces (2 Front 2 Rear) Review:


4 Wheel covers for less than the price of one! Have you lost a or damaged a wheel cover? Maybe tired of your outdated style? This could be your solution.
I've used this type of replacement on two vehicles over the years. Couldn't be more pleased. What a deal!
Casual observers won't notice the difference between these and ridiculously expensive factory replacements.
Easy to install. If your original covers were secured with lug nuts, you will have to jack up tire and remove nuts. But, these covers will fit right over lug nuts; no need to ever again use a jack to service or replace.
At the price, you can change styles every few years if desired.
Great gift for that relative who is driving around with that ugly unadorned tire